Our Blog

Sub Plates Explained – The Connective Layer in CNC Workholding

Most shops know their machine table. Most shops know their fixtures. The piece between them gets less attention, and that is usually where setup time and repeatability problems start. The CNC sub plate is a precision-ground flat plate that mounts directly to the machine table and creates a stable, reusable interface for all the workholding …

Sub Plates Explained – The Connective Layer in CNC Workholding Read More »

What is 5-Axis Workholding and When Do You Need It?

You bought a 5-axis machine to cut cycle times, reduce setups, and hold tighter tolerances. Then you bolted a standard Kurt vise onto the trunnion table, the spindle nose buried itself into the jaw on a B-axis move, and suddenly that machine is running like a three-axis knee mill with a six-figure price tag. This …

What is 5-Axis Workholding and When Do You Need It? Read More »

Modular Vise vs Standard Vise – Productivity Comparison

If you’re still running standard vises on your HMC or VMC, you’re likely leaving machine capacity on the table every cycle. The question isn’t whether a modular vise system outperforms a standard vise, it does, and the numbers aren’t close. The real question is: how much productivity are you giving up, and does the switch …

Modular Vise vs Standard Vise – Productivity Comparison Read More »